用途和特点： M、AH、HH型泵为悬臂、卧式离心 渣浆泵。 适用于冶金、矿山、煤炭、电力、建材等工业部门输送强磨蚀、高浓度渣浆。 该类型泵可以多级串联使用。 M、AH、HH型泵的泵体具备可更换的耐磨金属内衬，叶轮采用耐磨金属或橡胶材料。 HH型泵的泵体内衬和叶轮仅采用耐磨金属。 M、AH、HH型泵的轴封可采用填料密封，离心式密封（或机械密封）。 泵的吐出口位置可以根据需要按45°间隔，旋转八个不同的角度安装使用。
USES AND FEATURES
M、AH，and HH model pumple pumps are cantilever and horizontal centrifgal slurry pumps.They are designed for the handlind highly abrasive,high con centraion slurries.They are widely used in metallurgy industry,mining industry and so on.The pumps of this model also can beinstalled as multi-stage series punps.
Punp body of M、AH model punps has wearable metal liner or rubber liner punps.The impellers are made of wearable metal or rubber.Both the liner and impeller for HH model pumps are made of wearable metalonly.
The shaft seal system of M、AH and HH model pumps packing seal,centrifugal seal (of mechanical seal).The exit of pump canbe divded into eight parts,each of which is 45 degrees.So it can fufill the different requirements that handling slurry to different directions.
型号意义：
6/4E-AH（R）
6-泵吸入口直径
4-泵吐出口直径
E-托架形式
M、AH-渣浆泵
R-橡胶内衬
TYPE MEANING
6/4E-AH（R）
6-Diameter of pump intake
4-Diameter of pump exit
E-Bracket type
M、AH-Slurry punp
R-Rubber liner
选型简介：
参阅该泵性能曲线，选用流量范围应为：
M、AH型泵：
对高浓度，强磨蚀性浆液流量范围为40-80％
对中浓度，中磨蚀性浆液流量范围为40-100％
对低浓度，低磨蚀性浆液流量范围为40-120％
HH型泵：
对中浓度，中磨蚀性浆液流量范围40-80％
对低浓度，低磨蚀性浆液流量范围40-100％
（某转速下的最高效率点对应流量为100％） BRIEFINTRODUCTION:
Consulting the pump performance curve,the selected flow range of pumps should be as follows;
M、AH MODEL PUMP：
To high concentration,high abrasion slurry.it us 40-801%
To medium concentration,medium abrasion slurry,it is 40-100%
To low concentration,low abrasion slurry,it is 40-100%
(The flow which is relevant to the max.Efficiency is 100% at a certain rotate speed) |
